Initial use 17
devolo dLAN LiveCam
Make sure that all dLAN AV devices
that are to be connected to your net-
work are also connected to the mains
supply. A dLAN AV device switches
into standby mode after a short time if
no network device (e.g. a computer)
connected to the network interface is
switched on. In Standby mode, the
dLAN AV device cannot be accessed
over the mains supply network. As
soon as the network device (e.g. com-
puter) connected to the network inter-
face is switched on again, your dLAN
AV device can also be accessed via the
electrical wiring.
4.4 Setup instructions
The dLAN LiveCam can be installed and set up in vari-
ous ways:
쎲 Wall mounting to the sockets incorporated on the
side and underside of the housing
쎲 Installation on a camera base with the help of the
threaded hole in a common size on the underside
of the housing
쎲 Setting up the dLAN LiveCam on a level surface
Align the camera according to what you wish to re-
cord.
When setting up the camera,
make ABSOLUTELY certain that
neighbouring public or private
property or strangers are not be-
ing recorded. Only your property
and private space may be moni-
tored using the camera.
4.5 Connecting the dLAN LiveCam
햲 Connect the dLAN LiveCam to the mains supply
using the included power cable.
햳 In order to set up a dLAN AV network or add
another dLAN AV adapter, proceed as follows:
쑗 Connect the dLAN AV adapter via the
included network cable to a network jack on
your router or to another network component.
쑗 Plug the dLAN AV adapter into an available
electrical outlet.
햴 Once you have connected the dLAN LiveCam and
at least one dLAN AV adapter as described above,
your dLAN AV network has been set up. To secure
your dLAN AV network, continue with the config-
uration of your network. To do so, continue read-
To Next Page
Loading...
Need help?
General