To Next Page
J
Jessica FernandezAug 18, 2025
How to fix air leaks in DeWalt Air Compressor?
- DDennis ButlerAug 18, 2025
If you notice air leaks in your DeWalt air compressor, try tightening the fittings to resolve the issue.
How to fix air leaks in DeWalt Air Compressor?
If you notice air leaks in your DeWalt air compressor, try tightening the fittings to resolve the issue.
What to do if my DeWalt Air Compressor regulator is not adjusted correctly?
If the regulator on your DeWalt air compressor isn't properly adjusted for the accessory you're using, some pressure drop is normal. Adjust the regulator as instructed in One-turn Regulator under Description of Operation if pressure drop is excessive. Note that you should adjust the regulated pressure under flow conditions while the accessory is being used.
What to do if my DeWalt D2002M pump does not run due to safety fault?
If the pump on your DeWalt air compressor doesn't run because of a safety fault, cycle the On/Off Switch from "Off" to "On."
What to do if my DeWalt Air Compressor pump does not run because tank pressure is above cut-in pressure?
If the pump on your DeWalt air compressor doesn't run because the tank pressure is above the cut-in pressure, drain the tank to below the cut-in pressure when the pump turns on.
What to do if the regulator is damaged on my DeWalt D2002M?
If the regulator on your DeWalt air compressor is damaged, replace it.
What to do if the pressure switch does not shut off the motor when my DeWalt D2002M reaches cut-out pressure?
Set the Auto On/Off switch to "Off" and unplug unit, if the unit does not shut off contact a DeWALT factory service center or a DeWALT authorized service center.
What to do if my DeWalt D2002M has a hole in the air hose?
If you find a hole in the air hose of your DeWalt air compressor, replace the air hose.
What to do if the motor overload protection switch has tripped on my DeWalt Air Compressor?
If the motor overload protection switch on your DeWalt air compressor has tripped, refer to Motor Overload Protector under Description of Operation. If motor overload protection trips frequently, contact a DeWALT factory service center or a DeWALT authorized service center.
What to do if tube fittings are not tight enough on DeWalt D2002M?
If the tube fittings on your DeWalt air compressor aren't tight enough, tighten the fittings where you hear air escaping. Check the fittings with a soapy water solution, but do not overtighten.
What to do if my DeWalt D2002M is not large enough for accessory?
If your DeWalt air compressor isn't large enough for the accessory you're using, check the accessory's air requirement. If it's higher than the CFM or pressure supplied by your air compressor, you'll need a larger compressor to operate the accessory.
Details on the maintenance-free universal motor, voltage, and circuit requirements.
Lists tank capacity, cut-in/cut-out pressure, and airflow (SCFM).
Explains signal word meanings and provides initial safety advice.
Covers risks from flammable vapors, sparks, and contaminated air.
Dangers of air tank rupture due to corrosion or damage.
Precautions against electric shock and burns from hot parts.
Procedures for safely attaching and removing air hoses.
Ensuring proper grounding to prevent electrical shock.
Steps for safely operating, turning off, and maintaining the compressor.
Guidance on identifying and resolving frequent compressor malfunctions.
General| Model | D2002M |
|---|---|
| Tank Capacity | 2 Gallons |
| Power Source | Electric |
| Pump Type | Oil-Free |
| Voltage | 120V |
| SCFM @ 90 PSI | 2.6 SCFM |
