ENGLISH
39
• Keep handles and gripping surfaces dry,
clean, and free from oil and grease. This will
enable better control of the tool.
• Maintain firm grip with both hands on router
to resist starting torque.
• Keep hands away from cutting area. Never
reach under the workpiece for any reason.
Keep the router base firmly in contact with the
workpiece when cutting. These precautions will
reduce the risk of personal injury.
• Never run the motor unit when it is not
inserted in one of the router bases. The
motor is not designed to be handheld.
• Keep cutting pressure constant. Do not
overload motor.
• Check to see that the cord will not snag or
impede the routing operation.
• Use sharp cutters. Dull cutters may cause the
router to swerve or stall under pressure.
• Be sure that the motor has stopped
completely before you lay the router down. If
the cutter head is still spinning when the tool is
laid down, it could cause injury or damage.
• Be sure that the router cutter is clear of the
workpiece before starting the motor. If the
cutter is in contact with the workpiece when
the motor starts it could make the router jump,
causing damage or injury.
• ALWAYS disconnect tool from power source
before making adjustments or changing
cutters.
• Keep hands clear of cutter when motor is
running to prevent personal injury.
• Never touch the cutter immediately after
use. It may be extremely hot.
• Provide clearance under workpiece for
router cutter when through-cutting.
• Tighten collet nut securely to prevent the
cutter from slipping.
• Never tighten collet nut without a cutter.
• Do not use router cutters with a diameter in
excess of 30 mm in this tool.
• Avoid Climb-Cutting (cutting in direction
opposite that shown in fig. 12). Climb-
Cutting increases the chance for loss of
control resulting in possible injury. When
“Climb-Cutting” is required (backing around a
corner), exercise extreme caution to maintain
control of router. Make smaller cuts and remove
minimal material with each pass.
• Always use straight-cutters, rabbet-cutters,
profile cutters, slotter cutters or grooved knives
with a shank diameter of 6–8 mm which
corresponds to the size of the collet in your tool.
• Always use cutters suitable for a speed of
min. 30000 min
-1
and marked accordingly.
WARNING: Never use cutters with
a diameter exceeding the maximum
diameter indicated in the technical data.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing .
– Risk of personal injury due flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
DATE CODE POSITION (FIG. 1)
The Date Code (y), which also includes the year of
manufacture, is printed on the label.
Example:
2010 XX XX
Year of Manufacture
Package Contents
D26200
The package contains:
1 Router with fixed base
1 Fixed base dust collection
1 Basic parallel fence (D262003)
1 Collet 8 mm (GB: 1/4")
1 Wrench
To Next Page
Loading...
Need help?
General
