RIPPING (FIG. 13)
Ripping is the process of cutting wider boards into narrower strips –
cutting grain lengthwise. Hand guiding is more diffi cult for this type of
sawing and the use of a rip fence is recommended.
INSTALL RIP
FENCE
IN THIS
DIRECTION
FIG. 13
POCKET CUTTING (FIG. 14)
WARNING: Never tie the
FIG. 14
M
blade guard in a raised
position. Never move the saw
backwards when pocket
cutting. This may cause the
unit to raise up off the work
surface which could cause
injury.
A pocket cut is one that is made
in a fl oor, wall or other fl at surface.
1. Adjust the saw shoe so the blade cuts at desired depth.
2. Tilt the saw forward and rest front of the shoe on material to be cut.
3. Using the retracting lever, retract lower blade guard to an upward
position. Lower rear of shoe until blade teeth almost touch cutting
line.
4. Release the blade guard (its contact with the work will keep
it in position to open freely as you start the cut). Remove hand
from guard lever and fi rmly grip auxilary handle, (M) as shown
in Figure14. Position your body and arm to allow you to resist
kickback if it occurs.
5. Make sure blade is not in contact with cutting surface before
starting saw.
6. Start the motor and gradually lower the saw until its shoe rests fl at
on the material to be cut. Advance saw along the cutting line until
cut is completed.
7. Release trigger and allow blade to stop completely before
withdrawing the blade from the material.
8. When starting each new cut, repeat as above.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
depress the switch lock-off button and disconnect battery
pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can cause
injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
plastic materials used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
English
16
To Next Page
Loading...
