What to do if DeWalt DC608K headlights flash continuously?
If the headlights on your DeWalt Nail Gun flash continuously but the tool doesn't actuate, it may be due to a jammed fastener. To resolve this: * Remove the battery. * Clear the jammed fastener. * Push the driver blade back up manually if necessary. * Reinsert the battery pack.
Why DeWalt DC608K Nail Gun motor does not run?
If your DeWalt Nail Gun's headlights are on, but the motor doesn't run, it could be due to a few reasons: * The motor may stop running after 2 seconds, which is normal operation; release the trigger or contact trip and redepress. * The contact trip lock might be in the locked position (Sequential mode only): Unlock the contact trip lock.
What to do if DeWalt DC608K Nail Gun driver blade stuck down?
If the headlights are on, the motor runs, but the driver blade is stuck down on your DeWalt Nail Gun, check for: * Debris in the nosepiece: clean the nosepiece.
What to do if DeWalt DC608K Nail Gun doesn’t actuate (Headlights on, motor runs, driver blade stuck down)?
If the headlights are on, the motor runs, but the driver blade is stuck down on your DeWalt Nail Gun, it could be due to a damaged return system, debris in the nosepiece, or a damaged driver/return assembly. Try cleaning the nosepiece. If this doesn't solve the problem, the return system or driver/return assembly may need to be replaced by an authorized service center.
General| Type | Cordless |
|---|---|
| Voltage | 18V |
| Magazine Capacity | 110 nails |
| Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| Sequential Trigger | Yes |
| Firing Mode | Sequential |
| Nail Gauge | 18-gauge |
| Nail Length | 1-1/4" to 2-1/2" |
| Operating Pressure | Not applicable (cordless) |
| Nail Size | 1-1/4 in. to 2-1/2 in. |
To Next Page
