EasyManuals Logo

DeWalt DCB113 User Manual

DeWalt DCB113
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
4
ENGLISH
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3A.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1mm
2
; the maximum length
is30m.
When using a cable reel, always unwind the cablecompletely.
Battery Packs
Important Safety Instructions for All Battery
Packs
When ordering replacement battery packs, be sure to include
catalogue number andvoltage.
The battery pack is not fully charged out of the carton. Before
using the battery pack and charger, read the safety instructions
below. Then follow charging proceduresoutlined.
READ ALL INSTRUCTIONS
Do not charge or use battery in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Inserting or removing the battery from the charger may
ignite the dust orfumes.
Never force battery pack into charger. Do not modify
battery pack in any way to fit into a non‑compatible
charger as battery pack may rupture causing serious
personalinjury.
Charge the battery packs only in DeWALTchargers.
DO NOT splash or immerse in water or otherliquids.
Do not store or use the tool and battery pack in locations
where the temperature may fall below 4˚C (34 ˚F) (such
as outside sheds or metal buildings in winter), or reach
or exceed 40˚C (104 ˚F) (such as outside sheds or metal
buildings insummer).
Do not incinerate the battery pack even if it is severely
damaged or is completely worn out. The battery pack can
explode in a fire. Toxic fumes and materials are created when
lithium‑ion battery packs areburned.
If battery contents come into contact with the skin,
immediately wash area with mild soap and water. If
battery liquid gets into the eye, rinse water over the open eye
for 15minutes or until irritation ceases. If medical attention
is needed, the battery electrolyte is composed of a mixture of
liquid organic carbonates and lithiumsalts.
Contents of opened battery cells may cause respiratory
irritation. Provide fresh air. If symptoms persists, seek
medicalattention.
WARNING: Burn hazard. Battery liquid may be flammable
if exposed to spark orflame.
WARNING: Never attempt to open the battery pack for
any reason. If battery pack case is cracked or damaged,
do not insert into charger. Do not crush, drop or damage
battery pack. Do not use a battery pack or charger that
has received a sharp blow, been dropped, run over or
Chargers
DeWALT chargers require no adjustment and are designed to be
as easy as possible tooperate.
Electrical Safety
The charger has been designed for one voltage only. Always
check that the battery pack voltage corresponds to the voltage
on the rating plate. Also make sure that the voltage of your
charger corresponds to that of yourmains.
Your DeWALT charger is double insulated in
accordance with EN60335; therefore no earth wire
isrequired.
If the supply cord is damaged, it must be replaced only by
DeWALT or an authorised serviceorganisation.
WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA orless.
Mains Plug Replacement
(U.K.& Ireland Only)
If a new mains plug needs to be fitted:
Safely dispose of the oldplug.
Connect the brown lead to the live terminal in theplug.
Connect the blue lead to the neutralterminal.
WARNING: No connection is to be made to the
earthterminal.
may present a risk of injury to yourself
and/orothers.
The location at which the charger is
used should be clean and dry. Use in a
dirt or wet area could result in risk of fire,
electric shock, orelectrocution.
Disconnect the charger from the
outlet before attempting any
cleaning. This will reduce the risk of
electric shock. Removing the battery pack
will not reduce thisrisk.
Do not disassemble charger; take
it to an authorised service centre
when service or repair is required.
Incorrect reassembly may result in a risk
of electrical shock, electrocution orfire.
Do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way.
Take it to an authorised servicecentre.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DCB113 and is the answer not in the manual?

DeWalt DCB113 Specifications

General IconGeneral
Charger TypeBattery Charger
Voltage12V/20V MAX
Input Voltage120V AC
Charging ChemistryLithium Ion
Charging Current3.0 A
Overcharge ProtectionYes
CompatibilityDEWALT 12V MAX* and 20V MAX* Batteries
Output Voltage12V/20V Max
LED IndicatorsYes
Weight1.5 lbs

Related product manuals