HH
Safety Notes
Before attempting any repairs, the following should be observed,
Ensure that the correct tool is used and only use good quality hand tools.
Ensure the work shop is clean and tidy.
Always wear protective clothing, Overalls, safety gloves, safety glasses, safety hat/net
etc.
Check that guards function correctly, if not repair before running the product.
Before turning product on for analysis carry out a visual check for loose/broken parts
Including accessories, blades, cutters etc.
Carry out an Earth continuity, Earth leakage and Insulation test (flash test) where
appropriate.
Never repair a product whilst it is plugged into a power supply
Remove all accessories, blades, cutters etc.
Release tension on parts before attempting to remove, for example arm springs.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
