DeWalt DCMBL562N - Maintenance; Protecting the Environment; Rechargeable Battery Pack

11
ENGLISH
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
householdwaste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
thetool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed ofproperly.
Accessories

WARNING: Since accessories, other than
those offered by D
eWALT, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
D
eWALT recommended accessories should be used with
thisproduct.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D
eWALT call 1-800-4-DeWALT (1-800-433-9258) or visit our
website: www.dewalt.com.
Cleaning and user maintenance shall not be made by children
withoutsupervision.
Cleaning

WARNING: Blow dirt and dust out of the
main housing with dry air as often as dirt is seen collecting
in and around the air vents. Wear approved eye protection
and approved dust mask when performing thisprocedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the materials used in
these parts. Use a cloth dampened only with water and
Lubrication
Your power tool requires no additionallubrication.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regularcleaning.

WARNING: To reduce the risk of serious
personal injury, turn tool off and disconnect battery
pack before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can causeinjury.
The charger and battery pack are notserviceable.
Switching On (Fig.A, F)

CAUTION: Do not point unit discharge at self
orbystanders.

CAUTION: Always wear safety glasses. Wear
a filter mask if the operation is dusty. Use of gloves, long
pants and substantial footwear is recommended. Keep
long hair and loose clothing away from openings and
movingparts.
• To turn the blower ON, ensure the speed lock lever
2
is in
the off position and depress the trigger switch
1
.
• To lock the blower ON, push the speed lock lever
2
forward,
as shown in Fig. F. The blower runs at higher speeds as
the lever is moved further. The speed lock lever can also be
pushed forward to start the blower without needing to first
depress the triggerswitch.
• To turn the blower OFF, release the trigger switch
1
and or
pull back on the speed lock lever and return it to its offposition.
Proper hand position requires one hand on the main handle
3
.
mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into aliquid.