60
english
SYMPTOM CAUSE FIX
Tool operates but does
not drive fasteners fully
Depth adjust set too shallow Rotate depth adjust to a deeper setting.
Tool not firmly applied to workpiece Apply adequate force to tool securing it tightly to
workpiece. Refer to instruction manual.
Material and fastener length If the unit continues to stall(forcing the need
to rotate the Stall release lever) choose the
appropriate material and fastener length that is not
too rigorous of an application.
Damaged or worn driver blade tip Replace driver/return assembly. See authorised
repair agent.
Damaged actuation mechanism See authorised
repair agent.
Tool is not yet run-in New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
Use of incorrect speed(DCN693 only) If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
Tool operates, but no
fastener is driven
No nails in magazine Load nails in magazine.
Wrong size or angle nails Use only the recommended nails. Refer to
Technical Data.
Debris in nosepiece Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
Debris in magazine Clean magazine.
Worn magazine Replace magazine. See authorised
repair
agent.
Damaged or worn driver blade See authorised
repair agent.
Damaged pusher spring Replace spring; see authorised
repair
agent.
Jammed nail Wrong size or angle nails Use only the recommended nails. Refer to
Technical Data.
Magazine screws not secured after
previous jam clear/inspection
Make sure to tighten magazine hex bolts with
wrench provided.
Damaged or worn driver blade Replace driver blade. See authorised
repair agent.
Material and fastener length If the unit continues to stall(forcing the need
to rotate the Stall release lever) choose the
appropriate material and fastener length that is not
too rigorous an application.
Debris in nosepiece Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
Worn magazine Replace magazine. See authorised
repair
agent.
Dry drive lock out is engaged with only
7-9 nails remaining in magazine and
the user is applying excessive force to
contact trip, overriding the lockout
Load more nails in magazine to disengage dry drive
lockout.
Tool is not yet run-in New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
Use of incorrect speed(DCN693 only) If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
Poor driving hole
performance
Damaged or worn hole locating tip Replace tip with kit. If poor performace remains
take tool to an authorised
To Next Page
Loading...
