EasyManua.ls Logo

DeWalt DCT411 - Hook, Magnet and Mirror DCT411; Troubleshooting; Maintenance

DeWalt DCT411
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
English
MAINTENANCE
Cleaning
WARNING: Blow dirt and dust off with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Troubleshooting
Make sure the 12V Max* battery is charged.
Make sure the screen is fully charged.
Make sure the screen is always attached to the handle set. The
picture may freeze if you attempt to remove the (screen) from the
handle set while taking a photo or video.
Make sure the battery is installed on the handle set when in use.
Make sure the camera cable is attached to the handle set properly.
Make sure the handle set is turned on as well as the screen.
Make sure the back of the handle set is not covered with debris so
the screen slides on easily and no damage to the screen occurs.
If the screen freezes or won't turn on, insert a small object (i.e.,
paper clip end) into the reset button located on the back of the
screen.
If the picture is dim, roll the brightness control switch to brighten
the LED light.
Accessories
WARNING: Since accessories, other than those offered by
D
EWALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
EWALT recommended accessories should be used with
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
EWALT
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call
1-800-4-D
EWALT (1-800-433-9258) or visit our website www.dewalt.
com.
RECOMMENDED ACCESSORIES
Camera cable: 17mm diameter
Camera cable: 9mm diameter
Camera cable: 5.8mm diameter
3' (.91m) cable extension: 17mm diameter
Hook and magnet (DCT410)
Hook, magnet and mirror (DCT411)
Please contact D
EWALT Industrial Tool Co., 701 East Joppa Road,
Baltimore, MD 21286, call 1-800-4-D
EWALT (1-800-433-9258) or visit
our website www.dewalt.com.
Repairs
The charger, battery pack and inspection camera are not serviceable.
There are no serviceable parts inside the charger, battery pack or
inspection camera.

Other manuals for DeWalt DCT411

Related product manuals