22
SECTION F. RECIPROCATING SAW DW008
material before continuing with pocket cut.
Note: In areas where blade visibility is limited,
use the edge of the saw shoe as a guide. Lines
for any given cut should be extended beyond
edge of cut to be made.
MAINTENANCE
Lubrication
Your tool was properly lubricated before leaving
the factory. In from two to six months, depending
on use, take or send your tool to a Service Centre, or authorised service station, for a
complete cleaning, inspection and lubrication. Tools used constantly on production
jobs will need relubrication more often. Also, tools “out of service” for long periods
should be relubricated before being put back to work.
Contact 1800 654 155 for Service Centre locations.
ACCESSORIES
Recommended accessories for use with your tool are available at extra cost from
your local service centre.
Caution: The use of any non-recommended accessory may be hazardous. A
complete listing of service centres is included with your tool. If you need assistance
in locating any accessory, please contact:
Australia: 1800 816 900 N.Z.: 09 579 7600.
F10
To Next Page
Loading...
Need help?
General
