DeWalt DW030 - Page 50

english
48
3. Press the DIST (ON) button (e) once to record the measurement in
the LCD display (d).
CONTINUOUS DISTANCE MEASURING
DIST
(FIG. 3, 4, 7)
1. Press the DIST (ON) button (e) once to turn the LDM on.
2. Aim the LDM at the desired target.
3. Press and hold the DIST (ON) button (e) for three seconds to
activate Continuous Distance Measuring mode. Move the LDM to
measure desired distance. The letters ‘trc’ (tracking) will flash on
the LCD display.
NOTE: When the LDM is in Continuous Distance Measuring
mode, the laser indicator (l) turns on steady.
4. Press the DIST (ON) button (e) once to stop continuous measuring.
Functions
TO ADD OR SUBTRACT MEASUREMENTS
1. Turn the LDM on.
2. Aim the LDM at the desired target.
3. Press the DIST (ON) button (e) once to measure the first distance.
4. Press the + or – button (k, j) to activate the add or subtract
function. The + or – will show in the display.
5. Press the DIST (ON) button again to add or subtract the second
measurement. The calculated results show in the main reading line.
The second measurement will show in the additional reading line.
TO SELECT UNITS OF MEASURE
U
NIT
S
UNITS
(FIG. 3)
The LDM switches to the next unit of measure each time the button (g)
is pressed.
TO MEASURE AREA
(FIG. 3, 4, 8)
1. Turn the LDM on.