DeWalt DW030 - Page 51

english
49
2. Press the area measure button (h). The area icon will display.
3. Aim the LDM at the first desired target, as shown. Press the DIST
(ON) button (e) once to record the first distance.
4. Aim the LDM at the second desired target and press the DIST
(ON) button (e) once to record the second distance.
5. The calculated area is displayed in the main reading line (s). The
second measurement is displayed in the additional reading line (p).
NOTE: The final measurement is displayed as square feet or
square meters.
TO MEASURE ROOM VOLUME
(FIG. 3, 4, 9)
1. Turn the LDM on.
2. Press the volume measure button (i). The volume icon will display.
3. Aim the LDM at the first desired target, as shown. Press the DIST
(ON) button (e) once to record the first distance.
4. Aim the LDM at the second desired target and press the DIST
(ON) button (e) once to record the second distance.
5. Aim the LDM at the third desired target and press the DIST (ON)
button (e) once to record the third distance.
6. The calculated volume is displayed in the main reading line (s). The
third measurement is displayed in the additional reading line (p).
NOTE: The final measurement is displayed as cubic feet or cubic
meters.
LASER MAINTENANCE
IMPORTANT: Disassembling the LDM will void all warranty on the
product.
 • Undersomeconditions,thelensofthelaseremitterandthe
receiver may collect some dirt or debris. This will affect beam
quality and operating range. The lens should be cleaned with a
cotton swab moistened with water as shown in figure 6.