DeWalt DW030 - Page 52

english
50
WARNING: DO NOT turn the LDM on while cleaning
thelens.Seriouseyeinjurymayresultfromstaringatthe
beam.
 • Thehousingcanbecleanedwithawetlint-freeclothsuchasa
cotton cloth. USE WATER ONLY — DO NOT use cleansers or
solvents. Allow the LDM to air dry before storing.
 • Tomaintaintheaccuracyofyourreadings,performcontrol
measurements periodically. Refer to Field Calibration Check.
 • IfyourLDMrequiresrepair,contactyourlocalDeWA LT service
center.
 • WhentheLDMisnotinuse,storeitinthepouchprovided.
 • DonotstoreyourLDMinthepouchifitiswet.Dryexteriorparts
with a soft, dry cloth and allow the LDM to air dry.
 • DonotstoreyourLDMattemperaturesbelow–7˚C(20˚F)or
above70˚C(160˚F).
CAUTION: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the laser. These
chemicals may weaken the materials used in these parts.
Useaclothdampenedonlywithwaterandmildsoap.
Never let any liquid get inside the unit; never immerse any
part of the unit into a liquid. Never use compressed air to
clean the laser.
Field Calibration Check
Measure a known distance [within a 3–10 m (10–30') range] with the
LDM to confirm that the LDM is functioning properly.
Laser Accessories
Recommended accessories for use with your LDM are available at
extra cost from your local service center.