DeWalt DW0822 - Using the Lasers with Accessories; Maintenance; Accuracy Checks and Repairs; Storage Guidelines

ENGLISH
15
• The bracket has magnets
12
which allow the unit to be mounted to most upright surfaces
made of steel or iron. Common examples of suitable surfaces include steel framing studs, steel
door frames, and structural steelbeams.
Using the Lasers with Accessories
The lasers are equipped with a 1/4” x 20female thread on the bottom of the unit. This thread
is to accommodate current or future DeWALT accessories. Only use DeWALT accessories
specified for use with this product. Follow the directions included with theaccessory.

CAUTION: The use of any other accessory not recommended for use with this tool could
behazardous.
If you need any assistance in locating any accessory, please contact DeWALT Industrial Tool
Co., 701East Joppa Road, Towson, MD 21286or call 1–800–4‑DeWALT (1–800–433–9258).
See our catalog on the World Wide Web at www.DeWALT.com.
Maintenance
• To maintain the accuracy of your work, check the laser often to make sure it is properly
calibrated. See Field CalibrationCheck.
• Calibration checks and other maintenance repairs may be performed by DeWALT
servicecenters.
• When not in use, store the laser in the kit box provided. Do not store your laser at
temperatures below ‑5˚F (‑20˚C or above 140˚F (60˚C).
• Do not store your laser in the kit box if the laser is wet. The laser should be dried first with
a soft dry cloth prior tostorage.
Cleaning
Exterior plastic parts may be cleaned with a damp cloth. Although these parts are solvent
resistant, NEVER use solvents. Use a soft, dry cloth to remove moisture from the tool
beforestorage.
Troubleshooting
The Laser Does Not Turn On
• Remove the batteries and replace with fresh batteries. Ensure the battery contacts are
free ofcorrosion.