DeWalt DW0822 - FCC Compliance Statement; FCC Compliance Measures; ISED Compliance Statement; ISED Compliance Conditions

ENGLISH
6
DeWALT
701East Joppa Road
Towson, Maryland 21286
www.DeWALT.com
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio and television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receivingantenna.
• Increase the separation between the equipment andreceiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver isconnected.
• Consult the dealer or an experienced radio/TV technician forhelp.
ISED Compliance Statement
This device contains license‑exempt transmitter(s)/receiver(s) that comply with Innovation,
Science, and Economic Development Canada's license‑exempt RSS(s). Operation is subject
to the following twoconditions:
1. This device may not causeinterference.
2. This device must accept any interference, including interference that may cause
undesired operation of thedevice.
USER SAFETY
Definitions: Safety Alert Symbols and Words
This instruction manual uses the following safety alert symbols and words to alert you to
hazardous situations and your risk of personal injury or propertydamage.

DANGER: Indicates an imminently hazardous situation which, if not avoided, will result
in death or seriousinjury.