DeWalt DW088 - End of Life

54
ENGLISH
• Switch on the vertical laser beam.
• Align the laser beam with the floor marking
35
.
• Mark the centre of the laser beam at one-third distance
38
and at two-third distance
39
on the ceiling.
• Switch off the tool.
• Measure the difference between the markings (
36
,
38
).
• Measure the difference between the markings (
37
,
39
).
• If the difference between the markings is 3.5 mm or less, the tool is properly calibrated.
• If the difference between the markings is more than 3.5 mm, the tool must be serviced.
Cleaning
• Remove the batteries before cleaning the tool.
• Regularly clean the housing with a soft cloth.
• When necessary, clean the lens using a soft cloth or a cotton bud soaked in alcohol. Do
not use any other cleaning agents.
End of Life
• Do not dispose of this product with householdwaste.
• Always dispose of batteries per localcode.
• Please recycle in line with local provisions for the collection and disposal of electrical
and electronic waste.
Batteries
When disposing batteries, think of the protection of the environment. Check with your local
authorities for an environmentally safe way of battery disposal.