2
Voltage decrease of more than 10% will cause loss of power and
overheating. All DeWalt tools are factory tested; if this tool does not
operate, check the power supply.
Additional Specific Instructions for
Routers
The electronic motor control system has two basic features.
A. Soft start - when you turn on the router, you will notice that it
does not have the jerk from the rapid acceleration of the motor.
This router has a starting circuit which accelerates the motor up to
speed smoothly, without jerking, and allows you to maintain easier
control of the router during the start up period.
B. Constant speed cutting - as you load the router, the selected
cutting speed does not slow down during normal use. The
electronic control governs the motor and gives you a consistent
finish to your work. Only under very heavy loading will the speed of
the unit fall below the governed speed.
To set the router speed (from 8,000 rpm to 20,000 rpm) rotate the
speed control wheel shown in the large figure on page 2. The
higher the number the higher the speed. Consult TABLE 1 (page 3)
to help select the proper speed for your application.
Specifications
PREPARATION FOR USE
The motor in this router is high-powered (750 Watts, max.). Despite
this, it is advisable to cut deep grooves or remove large amounts of
material in two or more passes.
Operating Instructions
TURN OFF AND UNPLUG ROUTER
N O T E : Before installing a router bit in your unit, position the tool so
that the collet is easily accessible. To do this, rotate the height stop
thumb wheel, shown in Figure 1, counterclockwise until it is about
1/2” from the top of the threaded height stop rod. Raise the plunge
release lever, shown in Figure 2, and let the router rise to its full
height. Depress the plunge release lever to lock the tool in place.
TECHNICAL DATA
M o d e l DW624, DW625
V o l t a g e 1 2 0
Speed DW624 20,000 r.p.m.
Speed DW625 8,000- 20,000 r.p.m.
I n s u l a t i o n double insulated
C o l u m n spring loaded twin column
Plunging stroke 70mm (2-3/4”)
Routing depth 0-70 mm adjustable
Cutter mounting precision collet, size 1/2”-1/4”
Cutter cap max. 63.5 mm (2-1/2")
R o u t i n g (shallow)
Rotary depth stop 3 stage depth position
HEIGHT STOP THUMB
WHEEL
FIG. 1
1/2
QUICK
RELEASE
BUTTON
SPEED
CONTROL
WHEEL
328521-01/DW624 9/6/01 8:00 AM Page 2
To Next Page
Loading...
Need help?
General
