DeWalt DW735-XE - Product Overview and Features

7
ENGLISH
• Always locate planer with proper clearance on the outfeed
side of the unit to prevent pinching or binding of the workpiece
against any obstacle.
• Maintain the proper relationships of infeed and outfeed table
surfaces and cutterhead knife path.

WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Residual Risks
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
• Impairment ofhearing.
• Risk of personal injury due to flyingparticles.
• Risk of burns due to accessories becoming hot
duringoperation.
• Risk of personal injury due to prolongeduse.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the voltage
on the rating plate.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the DeWALT
serviceorganisation.
Using an Extension Cable
If an extension cable is required, use an approved 3–core
extension cable suitable for the power input of this tool (see
Technical Data).The minimum conductor size is 1.5 mm
2
; the
maximum length is 30 m.
When using a cable reel, always unwind the cablecompletely.
Package Contents
The package contains:
1 Heavy-duty planer
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Date Code Position
The date code, which also includes the year of manufacture, is
printed into thehousing.
Example:
2020 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Planer
2
Side carrying handles
3
Base handles
4
Bench mounting holes
5
Crank handle
6
On/off switch
7
T-wrench
Intended Use
This planer is designed for professional woodworking.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with thisproduct.
Fan-Assisted Chip Ejection System
Your planer is equipped with a fan-assisted chip ejection system
to aid in exhausting chips from the unit. The fan-assisted chip
ejection system will work in conjunction with independent dust
collectionsystems.
NOTE: It is not recommended that a shop vac be connected
to the DW735. The capacity of most vacs does not support
the volume of chips ejected during planing. The vacuum hose
may clog stopping the flow of chips. It is recommended to use
the dust collection system to clean debris from the interior of
thetool.
See the Troubleshooting Guide, for additionalinformation.
Automatic Carriage Lock
There is no manual carriage lock on your planer. A device that
automatically minimizes the movement that causes snipe
during planing is designed into the four threadedposts.