6
ENGLISH
g) If devices are provided for the connection
of dust extraction and collection facilities,
ensure these are connected and properly
used. Use of dust collection can reduce
dust-related hazards.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the switch
is dangerous and must be repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool’s operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with these
instructions taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
WARNING: Never operate the
appliance with defective guards or
shields, without safety devices or if the
cord is damaged or worn.
Additional Safety Instructions for
Blowers
• Do not collect smoldering cigarette ashes,
freshly cut metal shavings, screws, nails and
the like.
• This appliance is for dry use only. DO NOT
collect liquid.
• Use in a dry location only. Do not allow the
appliance to become wet.
• Do not immerse the appliance in water.
• Never block suction inlet and outlet.
• Do not cross gravel paths or roads whilst
your product is switched on during blow/vac
mode. Walk, never run.
• Always be sure of your footing, particularly
on slopes.
• Do not overreach and keep your balance at
all times.
• Do not place the inlet or outlet of the
vacuum near eyes or ears when operating.
Never blow debris in the direction of bystanders.
• Always direct the power supply cord to the rear
away from the appliance.
• Keep all cooling air inlets clear of debris.
• To protect your feet and legs while operating
the appliance, always wear heavy-duty
footwear and long trousers.
• Never allow children to use the appliance.
Children should be supervised to ensure that
they do not play with the appliance.
• Keep children, bystanders and animals away
while operating this appliance.
• Before use, check the power supply cord and
extension cord for signs of damage, ageing
and wear. If a cord becomes damaged during
use, disconnect the cord from the mains supply
immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
• Only use an extension cord suitable for
outdoor use fitted with a coupler according
to IEC 60320-2-3.
• Wear protective goggles while operating.
• If operating an appliance in a damp location
is unavoidable, use a Residual Current
Device (RCD) with a tripping current of not
more than 30mA protected supply. Use of an
RCD reduces the risk of electric shock.
• To prevent dust irritation, wearing of a face
mask is recommended.
To Next Page
Loading...
