8
ENGLISH
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills. Children should
never be left alone with this product.
• This appliance is intended for commercial
use, for example in hotels, schools, hospitals,
factories, shops, offices and rental businesses.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your DEWALT tool is double insulated in
accordance with EN60745-1; therefore
no earth wire is required.
WARNING: 115 V units have
to be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
In case of damaged power supply cord the
supply cord must be replaced immediately by the
manufacturer, its service agent or similar qualified
person to prevent any hazard.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved 3–
core extension cable (type: H05 RN-F, or H05VV-F)
suitable for the power input of this tool (see
Technical Data).The minimum conductor size is 1.5
mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the
risk of injury, turn unit off and
disconnect machine from power
source before installing and
removing accessories, before
adjusting or changing set-ups or
when making repairs. Be sure the
trigger switch is in the OFF position. An
accidental start-up can cause injury.
Mounting the Nozzle for Blowing
Operations (fig. 1)
Insert the pin located inside the nozzle (a) into the
notch provided on the blast port (b)
To lock nozzle in place, turn the nozzle in the
direction indicated.
To remove nozzle, turn the nozzle in the opposite
direction.
Mounting the Nozzle and Dust Bag
for Dust Collection (fig. 2)
WARNING: When using the
suction port the dust bag MUST be
mounted to the blast port to prevent
injury from flying debris.
For dust collection, mount the dust bag at the blast
port (b) and nozzle at the suction port (f).
To remove dust bag and nozzle, simply pull out by
first turning in the opposite direction.
Empty the dust bag frequently to ensure maximum
dust collecting efficiency.
OPERATION
Instructions for Use
WARNING: Always observe
the safety instructions and applicable
regulations.
Operating the Blower (fig. 1, 3)
• To switch your blower on, depress the switch
(c). To stop your blower, release switch.
• Adjust variable speed knob (d) for different
speed requirement.
• When continuous operation is required, first
depress the switch and then the lock-on button
(e) and release to disengage lock, squeeze and
release switch.
To Next Page
Loading...
