DeWalt DWE4212 - Prior to Operation

ENGLISH
8
1 Hex key
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
duringtransport.
• Take the time to thoroughly read and
understand this manual prior tooperation.
Description (fi g. 1–3)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury couldresult.
a. Spindle lock button
b. Spindle
c. Side handle
d. Backing flange
e. Threaded locking flange
f. Guard
g. Slider switch (DWE4205, DWE4215)
h. Paddle switch (DWE4212)
i. Lock-off lever (DWE4212)
j. Dust ejection system
k. Screw
l. Nut
m. Hex key
INTENDED USE
The DWE4205, DWE4212 and DWE4215 heavy-
duty small angle grinders have been designed for
professional grinding, sanding, wire brushing and
cuttingapplications.
DO NOT use grinding wheels other than centre
depressed wheels and flapdiscs.
DO NOT use under wet conditions or in the
presence of flammable liquids orgases.
These heavy-duty angle grinders are professional
power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use thistool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
thisproduct.
Anti-vibration Side Handle
The anti-vibration side handle offers added comfort
by absorbing the vibrations caused by thetool.
Dust Ejection System (fi g. 1)
The dust ejection system (j) prevents dust pile-up
around the guard and motor inlet, and minimises the
amount of dust entering the motorhousing.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your DEWALT tool is double insulated in
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 127 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DEWALT service organisation.
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm
2
; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before