English
6
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may contribute
to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their defi nitions are as follows:
V .............. volts A ...........amperes
Hz ............ hertz W ..........watts
min .......... minutes
........ alternating current
....... direct current ........ alternating or
............ Class I Construction ............. direct current
................ (grounded)
n
o .........no load speed
............ Class II Construction n ...........rated speed
................ (double insulated) .........earthing terminal
…/min ..... per minute
..........safety alert
IPM .......... impacts per minute
............. symbol
BPM ........ beats per minute SPM .....strokes per minute
RPM ........ revolutions per sfpm .....surface feet per
minute
............. minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking. Voltage
decrease of more than 10% will cause loss of power and overheating.
D
EWALT tools are factory tested; if this tool does not operate, check
power supply.
WARNING: Accessories must be rated for at least the speed
recommended on the tool warning label. Accessories running over
rated speed can fl y apart and cause injury. Accessory ratings must
always be above tool speed as shown on tool nameplate.
WARNING: Avoid contact with the blade teeth to prevent personal
injury.
COMPONENTS (Fig. 1–3, 8)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Plunge trigger O. Outer fl ange
B. On/off switch P. Inner fl ange
C. Main handle Q. Riving knife
D. Shoe R. Riving knife adjustment screws
E. Bevel adjustment knob S. Speed wheel
F. Depth adjustment knobs T. Cutting indicator
G. Depth scale U. Anti-kickback knob
H. Front handle V. Outer guard
I. Dust extraction outlet W. Track
J. Track adjuster X. Bevel scale
K. Blade Y. Blade position indicators
L. Lock button Z. Hex wrench
M. Lock lever
N. Blade clamping screw
To Next Page
Loading...
Need help?
General
