DeWalt DXAEJ14 - User Manual

Questions and Answers

D
David RiveraJul 29, 2025
What to do if DeWalt Remote Starter USB port will not power appliance?
- A
  Andrew MeltonJul 30, 2025
  If your DeWalt Remote Starter's USB port isn't powering appliances, first ensure the USB Power Button is switched on. Also, a fault condition might exist in one of the USB Ports, refer to the Important Notes in the “USB Ports” section to remedy any faults. Verify that the USB device plugged into the USB-A port does not exceed 15W; the USB device plugged into USB-C port does not exceed PD 25W; or the total drained power of the USB-A port and USB-C port do not exceed 15W when they are used simultaneously. Some USB-powered household electronics may not be compatible with this USB charging/power port, so check the device's manual. Finally, ensure the unit is fully charged; recharge if necessary.
R
riversjohnnyAug 8, 2025
What to do if DeWalt Remote Starter unit fails to jump-start?
- A
  Andres ElliottAug 9, 2025
  If your DeWalt Remote Starter fails to jump-start, ensure the Jump Starter Power Switch is in the on position. Also, make sure a proper polarity cable connection has been established. Verify that the unit is not in Compressor mode and that it has a full charge. Recharge the unit if necessary.
C
cynthia04Aug 19, 2025
Why DeWalt Remote Starter portable compressor will not inflate?
- D
  danielellisAug 19, 2025
  If the portable compressor on your DeWalt Remote Starter won't inflate, first ensure the Compressor Power Button is on and that the unit isn't in Jump Starter mode. Check that the Sure Fit® nozzle is securely screwed onto the valve stem when inflating tires. Finally, ensure the unit is fully charged; recharge if needed.