WARNING:
To reduce the risk of re or explosion, do not
operate this vac in areas with ammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter uid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited
to: coal, magnesium, aluminum, and grain
or gun powder. Do not vacuum explosive
dust, ammable or combustible liquids or
hot ashes. Do not use this vac as a sprayer
for any ammable or combustible liquid. To
reduce the risk of health hazards from vapors
or dusts, do not vacuum toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
After you plug the power cord into the wall
receptacle, turn the unit "ON" by pushing
the switch from position "O" to position "I".
The "O" is the "OFF" position and the "I" is
the "ON" position.
ON
OFF
5
1. The lter must always be in correct
position to reduce the risk of leaks
and possible damage to vac. Make sure
that the lter is completely covering the
lter cage. Make sure there are no gaps
between the lter and the lid. It is very
important to assemble the lter to the
cage without any possible leaks or tears.
DRY PICK-UP
2. When using the vac to pick up ne dust, it
will be necessary to empty the dust tank and
clean or replace the lter at more frequent
intervals to maintain peak vac performance.
1. With the power head in an upside down position,
slide the cartridge lter down over the lid cage,
push the lter seals against the power head.
2. Turn the knob on lter retainer clockwise to
tighten, the lter into place.
3. To remove the lter for cleaning, turn the lter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the lter cap,
then slide the cartridge lter off the lid cage.
then grasp the step of knob tightly with ngers
to pull the cartridge lter out off the cage.
4. To clean the cartridge lter, shake or brush off
excess dirt or rinse (from the inside of the lter)
with water, dry completely (approximately 24
hours) and re-install.
The cartridge lter can be used for wet or dry
pick-up, installation is the same for both.
INSTALLING THE CARTRIDGE FILTER
NOTICE:
A dry lter is necessary to pick up dry material.
If use the vac to pick up dust when the lter is
wet, the lter will clog quickly and be very difcult
to clean. If the lter gets wet, replace it before
continuing to do dry pickups.
NOTICE:
If the lter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
ENGLISH
Lock
To Next Page
Loading...
Need help?
General
