7
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe with dry cloth.
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before changing or
cleaning the lter. The lter should be cleaned
often to maintain peak vac performance.
WARNING:
Do not remove lter cage and oat. The oat
prevents water from entering the impeller and
damaging the motor. The cage prevents ngers
from touching the moving impeller.
CLEANING:
To keep the wet/dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
NOTICE:
To avoid damage to the impeller and motor,
always reinstall the Clean Connect™ lter before
using the vac for dry pickups and wet pickups.
NOTICE:
After cleaning, check the lter for tears or small
holes. Do not use a lter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the lter on the vac, clean the
area of the lid so that the lter will seal against
the lid and stop small particles from bypassing
the lter bag. If the lter is clean and not
damaged, replace it on the lter cage.
If it cannot be reused, place a new lter over
the lter cage.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CARE AND MAINTENANCE
FILTER REPLACEMENT
ENGLISH
STORAGE:
Before storing the vac, the dust tank should
be emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in mesh bag so
they can be readily available. The vac should
be stored indoors.
To Next Page
Loading...
Need help?
General
