4
running but not actually doing the job. This may
significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect the
operator from the effects of vibration and/or
noise such as: maintain the tool and the
accessories, keep the hands warm (relevant for
vibration), organisation of work patterns.
EC‑ Declaration of Conformity
Machinery Directive
Hammerdrill DCD991, DCD996
DeWALT declares that these products described under
Technical Data are in compliance with:
2006/42/EC, EN62841‑ 1:2009+A11:2010,
EN62841‑ 2‑ 1:2010, EN62841‑ 2‑ 2.
These products also comply with Directive 2014/30/EU
and 2011/65/EU. For more information, please contact
DeWALT at the following address or refer to the back of
the manual.
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
DeWALT.
Markus Rompel
Vice‑ President Engineering, PTE‑ Europe
DeWALT, Richard‑ Klinger‑ Straße 11,
D‑ 65510, Idstein, Germany
22.05.2020
WARNING: To reduce the risk of injury, read the
instruction manual.
To Next Page
Loading...
