DeWalt XR DCM565N User Manual

18
ENGLISH
DCM565 TROUBLESHOOTING
Problem Solution
Unit will notstart. • Check batteryinstallation.
• Check battery
chargingrequirements.
• Check that lock off is fully pushed
down prior to moving maintrigger.
Unit shuts down
inuse.
• Chargebattery.
• Unit is being forced. Restart and
apply lesspressure.
Battery
won’tcharge.
• Insert battery into charger until red
charging light illuminates. Charge up
to 8 hours if battery is totallydrained.
• Plug charger into a working outlet.
Refer to Important Charging Notes
for moredetails.
• Check current at receptacle by
plugging anappliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
thelights.
• Move charger and appliance to
a surrounding air temperature of
above 4.5°C or below 40.5°C.
Bar /
Chainoverheated.
• Refer to Adjusting Chain
Tension section.
• Refer to
Chain Oiling section.
Chain isloose. • Refer to Adjusting Chain
Tensionsection.
Poor cutquality.
• Refer to Adjusting Chain
Tension section. NOTE: Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain section.
Unit runs but does
notcut.
• Chain could be installed backwards.
Refer to sections for installing and
removingchain.
Unit does notoil. • Refill oilreservoir.
• Clean guide bar, sprocket and
sprocket cover. Refer to Care And
Maintenancesection.
Protecting the Environment
w
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal householdwaste.
Products and batteries contain materials that can be
recovered or recycled, reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
Rechargeable Battery Pack
This long-life battery pack must be recharged when it fails to produce
sufficient power on jobs that were easily done before. At the end of
its technical life, discard it with due care for ourenvironment:
• Run the battery pack down completely, then remove it from
thetool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed ofproperly.

DeWalt XR DCM565N Specifications

General

Brand	DeWalt
Model	XR DCM565N
Category	Chainsaw
Language	English