DeWalt XR DCS355N User Manual

40
ENGLISH
DCS355D1/DCS355M1:
1 Li-Ion battery pack
DCS355D2/DCS355M2:
2 Li-Ion battery packs
NOTE: Battery packs, chargers and kitboxes are not
included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Variable speed trigger
b. LED Worklight
c. Accessory clamp lever
d. Lock on/off button
e. Accessory side mount slots
f. Cut guide block
g. Cut guide arm
h. Battery pack
i. Battery release button
j. Fuel gauge button
INTENDED USE
This oscillating multi-tool is designed for professional
detail sanding, plunge cutting, flush cutting, removal
of excess materials and surface preparation
applications.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This oscillating multi-tool is a professional power
tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge DEWALT battery packs only with
designated DEWALT chargers. Charging
battery packs other than the designated
DEWALT batteries with a DEWALT
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.
Package Contents
The package contains:
1 Adaptor for all blades
1 31mm x 43mm Fastcut wood blade
1 Sanding-pad
1 31 mm x 43 mm Wood with nails blade
1 Rigid scraper blade
1 Blade adaptor hex key
1 Instruction manual
1 Dust extraction adaptor
1 Cutting guide
1 100mm Semicircle blade
25 Assorted sandpaper pieces
1 9.5mm x 43mm Wood detail blade
1 3mm Carbide grout removal blade
(100mm half moon)
1 Cutting guide hex key
1 Charger
1 TSTAK kitbox

DeWalt XR DCS355N Specifications

General

Voltage	18V
Motor Type	Brushless
Oscillations per Minute	0-20, 000 OPM
Tool-Free Accessory Change	Yes
Power Source	Battery
Tool Length	310 mm
Quick Change Accessory System	Yes
LED Light	Yes
Model	DCS355N
Oscillation Angle	1.6 degrees
Battery Type	Lithium-Ion
Tool Length (inches)	12.2 inches