Operating Instructions
03
1. Remove the isolation tab in the battery compartment of the transmitter.
2. Press the ON/OFF button on the wall switch remote control to turn the
receiver on and off.
Note:
1. The program button of the receiver can also be used as a manual switch.
2. The receiver will remain "OFF" after a power cut to save energy.
Canceling Programming
To remove a receiver from all transmitter parings (no remote transmitter
can control it):
2. Release the program button and then press it again. The indicator light
will be off. All the programming has been canceled.
1. Press the program button on the receiver for 6 seconds until the indicator
light starts to flash rapidly. (Note: The light flashes from slowly to rapidly.)
To Next Page
Loading...
