03
Remote control outlets adopt variable learning codes technology.The codes
will be changed each time after re-programming. If this remote control outlet
happens to be in the same channels with other RF remote devices, just
re-program it and the interference will be eliminated.
No Interference
(Note: The flashing status of indicators go from: indicator 1 flashes slowly
- indicator 2 flashes slowly - indicator 1 and indicator 2 flash rapidly
simultaneously)
3. Release the program button and press it again, the indicator will go out,
and all programming will be canceled.
If you find the receivers works abnormally or the indicator on the remote
control becomes dim, please replace the battery.
- Open the battery compartment and remove the old battery.
- Install a new CR2032 battery, making sure the polarity + / - of the battery
is correct.
- Close the battery compartment.
Battery Replacement
- Input Voltage: 125VAC, 60Hz
- Max Power Rating: 15A, 1875W
- Transmission Frequency: 433.92 MHz
- Remote Control Range : 100 Feet (Free Area)
- Remote Battery: CR2032 3V
Specifications
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
1) this device may not cause harmful interference, and 2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC STATEMENT
To Next Page
Loading...