NDS3508B Tuner to IP Gateway User’s Manual
8
Chapter 3 WEB NMS operation
User can only control and set the configuration in computer by connecting the device to web
NMS Port. User should ensure that the computer’s IP address is different from the
NDS3508B’s IP address; otherwise, it would cause IP conflict.
3.1 login
The default IP of this device is 192.168.0.136.
Connect the PC and the device with net cable, and use ping command to confirm they are on
the same network segment.
I.G. the PC IP address is 192.168.99.252, we then change the device IP to 192.168.99.xxx (xxx
can be 0 to 255 except 252 to avoid IP conflict).
Use web browser to connect the device with PC by inputting this device’s IP address in the
browser’s address bar and press Enter.
It displays the Login interface as Figure-1. Input the Username and Password (Both the
default Username and Password are “admin”.) and then click “Login” to start the device
setting.
Figure-1
3.2 Operation
Summary → Status
When we confirm the login, it displays the status interface as Figure-2.
To Next Page
Loading...