The Choice of Professionals
www.diamatic.usa P a g e | 4 info@diamatic.usa
3. Operation
Priortouseormaintenance,t heoperator’smanualmustbereadca refullyandunderstoodbeforeusingthemachine.
1. Installation of the polishing pad
• Squeeze locking clip and remove snap on pad retainer.
• Select desire Florgrit pad
• Center pad on the pad driver and install pad retainer by pressing into place.
1. Handle Adjustment.
• Remove the thumbscrew on handle pivot. Raise or lower handle arm to comfortable position. Install pin and secure
with thumbscrew.
• Operator handle can be adjusted as well to the most comfortable position.
2. Connecting Power
• Ensure the motor switch is in the off position, speed control is at 0, the e-stop is in engaged and safety key is
removed.
• Connect the cable to plug to the inlet on the control panel.
• Connect the power cable to 230V Three Phase 30A circuit only!! (this should be done by an electrician)
To Next Page
Loading...