Diamond Kinetics SwingTracker - Page 4

Pulloneofthestrapendsoverasensormountwing,usingthetopholeinthe
strap.Pulleachofremainingtwostrapendsontherespectivesensormount
wing.

Confirmthatthesensorisfirmlysecuredbynudgingit.Ifthesensor
mountisloose,youcansecurethemountusingthesecondholeatthe
topofthestrap.

YourSwingTrackersensorshouldbeattachedtoyourbatontheknob
endonlyusingaSwingTrackerstrap.Donotuseanyothermechanismto
attachyoursensortoyourbat;doingsowillvoidthemanufacturer’s
warranty.



TurnOnYourSensor

Withthesensorattached,tapthebottomofbatonthegroundtwicetoturnonthe
sensor.Thelightwillbegintoflashquickly.Whenyoupairyoursensorunder
Settingsonyourdevice,thelightwillflashslowly.

Thesensorwillalsoautomaticallyturnoffafterafewminutesof
inactivity.

PairyourSensor
YouwillneedtopairtheSwingTrackersensortoyouriOSdeviceto
collectdata.
● GotoSettings>Bluetooth
● EnableBluetoothintheSettingsMenu,ifitisnotalreadyon.
● Selectthe"SwingTracker”sensor.
Oncepaired,yourappwillautomaticallyconnectwiththesensorforfuture
usewhenthesensorischargedandon.

IfyoudonotseeSwingTrackerinthedevicelist
● Confirmthatthesensorischarged.Ifitisnot,gotothe“Chargingyour
Sensor”section
● CheckthatitisnotconnectedtoanothernearbyiOSdevice.
● ConfirmSwingTrackerisclosetotheiOSdeviceandtryagain.

RemoveyourSensorfromtheChargingMount
Toremovesensorfrommount,pushdownandturnthesensor
counterclockwise1/8turntounlock.Removeinternalsensorfromsensor
mount.Sensorlightwillchangefromablinkingredtoasolidgreenlight
whenfullycharged.
