Need help?Do you have a question about the Diamond DC402/6-PS and is the answer not in the manual?
General| Brand | Diamond |
|---|---|
| Model | DC402/6-PS |
| Category | Dishwasher |
| Language | English |
Check packaging condition and report any damage. Handle packaging safely to avoid hazards.
Ensure installation area is suitable, protect from steam, and check floor support. Level the appliance.
Connect via omnipolar circuit breaker, match voltage/frequency, and ensure grounding system is operational.
Connect to water supply with a flexible hose and shut-off valve. Ensure compatibility with machine ratings.
Connect drain line to a free drain sump without stretching or blockage. Ensure sump is lower than machine base.
Dispensed by integral dispenser; doses set by installer. Use appropriate products and ensure sufficient fluid.
Specifies ambient temperature, altitude, and relative humidity limits for safe and optimal appliance operation.
Identifies buttons (ON/OFF, DRAIN, PROGRAMME, START) and LEDs (POWER, CYCLE UNDERWAY, HEATING).
Turn on main power, open water tap, check overflow, and press ON/OFF. Observe POWER and HEATING LEDs.
Use suitable racks, fill without overloading, wipe dishes, and place cutlery correctly for optimal washing.
Select cycle using PROGRAMME SELECTION, start with START button. Monitor CYCLE UNDERWAY LED.
Remove arms, wash under running water, clean nozzles, rotation pins, and drainage area.
Switch off, remove filter/overflow pipe, wait for tub to empty. Clean tub filter if necessary.
Follow steps to drain the tub when the appliance lacks a drain pump or it is not in use.
Use the DRAIN button to start the cycle for appliances equipped with an optional drain cycle.
Press ON/OFF button. POWER LED continues to flash, indicating power supply is active.
Run regeneration cycle periodically for water softener. Cycles depend on water hardness; consult table.
Before maintenance, drain water, shut off power and water. Do not use water under pressure.
Maintain the machine regularly. Periodically run a sanitising treatment with suitable products.
Procedure to remove and clean baskets, tub, and filters. Do not use abrasive products.
Remove arms, wash under running water, clean nozzles, rotation pins, and drainage area.
Interprets fast-flashing LEDs to diagnose malfunctions like safety devices, water filling, or temperature faults.
To Next Page
