Diamond G2SA77/9 - Starting production; Lighting open burners; Hotplate ignition; Lighting Gas Oven

10
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 10 -
INSTRUCTIONS FOR USE
5.
10- 10 -
3.
Starting production
Before proceeding with these operations, see "Daily
activation".
When loading the product into the appliance and
unloading it, there is a residual risk of being burnt; this
risk can occur coming into unintentional contact with:
hob - cooking compartment - recipients or material
processed.
Take appropriate measures for personal protection.
Wear protective equipment suitable for the operations
to be performed.
The products must be placed in the specic cooking
containers and positioned correctly on the burners
and/or in the cooking compartment of the oven.
The cooking recipients must have a diameter between
Ø 200 and Ø 375 mm.
When lighting for the rst time, wait for the possible
formation of air inside the gas circuit to fully escape
from the duct.
Lighting open burners (Fig. 1)
Turn the knob while holding it in the piezoelectric position
(Detail A Fig.1).
Position a ame (match or something else) on the pilot light
and wait for it to ignite (Fig. 1).
Release the knob after about 20” and check to make sure the
pilot light remains lit.
When the pilot light has been lit, turn the knob (Detail B Fig.1)
to minimum or maximum to adjust the ame.
Hotplate ignition (Fig. 2)
Turn the knob while holding it in the piezoelectric position (Fig.
2 Detail A), and simultaneously press the piezoelectric button
several times (Fig. 2 Detail B) until the pilot light is lit.
Release the knob after about 20” and check to make sure the
pilot light remains lit (Fig. 2).
The pilot light can be seen through the hole on the panel.
When the pilot light has been lit, turn the thermostat knob to
the desired temperature (Fig. 2 Detail C).
Lighting Gas Oven (Fig. 3)
Turn the knob while holding it in the piezoelectric position
(Fig.3 Detail C). Simultaneously press the piezoelectric button
several times (Fig.3 Detail D) until the pilot light is lit.
Release the knob after about 20” and check to make sure the
pilot light remains lit (Fig.3).
The pilot light can be seen through the hole on the oven top.
When the pilot light has been lit, turn the thermostat knob to
the desired temperature (Fig. 3 Detail E).
A B
3
0
0
2
7
0
2
5
0
2
3
0
2
1
0
1
9
0
.
1
7
0
Fig. 3
C
3
0
0
2
7
0
2
5
0
2
3
0
2
1
0
1
9
0
.
1
7
0
A B
Fig. 2
C
Fig. 1
A
B