Diamondback 64683 - Adjustments for Cutting

Page 12 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 64683
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
N"$*(%F9e'#$5*8$
M&$*- The Miter Gauge can be used from
either the left or the right side of the Blade.
1. Place the slot on the underside of the
Miter Gauge on the Table Fence.
2. Lock the Miter Gauge securely to the table by
turning the Gauge Lock Knob clockwise.
3. To adjust angles:
a. Loosen the Miter Lock Lever.
b. Set to the desired angle by moving
the Gauge left or right.
c. Tighten the Miter Lock Lever securely
before turning on the Saw.
R,'3*%
T&4`%^8&+
N"$*(%T&4`%
T*W*(
N"$*(%R,'3*%
G,+7*%
;*84*
N"$*(%R,'3*
S*W*7%F9e'#$5*8$
1. E7"9*%$.*%G,+7*%47*,(%&2%$.*%S7,9*%
$&%/(*W*8$%+7,9*%9,5,3*1
2. Loosen the Bevel Lock Lever.
3. Adjust the Motor Head to the desired angle:
[f=%ZZ1Bf%&(%gBf. U&%8&$%#*$%+*W*7%$&%
,8V%&$.*(%#*$$"831 The slots in the Table
are designed &87V for these cuts.
4. Tighten the Bevel Lock Lever.
S*W*7%T&4`%
T*W*(
S*W*7%T&4`%T*W*(
U*/$.%F9e'#$5*8$
1. U*/$.%T&4`- Use the Depth Lock to lock the
Motor Head in the down position; press it in while
the Motor Head is down to lock, and pull out
while holding down the Motor Head to unlock.
2. U*/$.%^8&+- The Depth Knob can be used to
lock the Motor Head at a particular cutting depth;
tighten it to lock the Motor Head in place,
loosen it to allow adjustment.
U*/$.%^8&+
U*/$.%
T&4`
U*/$.%O&8$(&7#