DiBO n.v. 61
Block- system
6. Mixing tap/chemical injection
With the mixing tap it is possible to set exactly the concentration of added (chemical) products:
* For the product on the right side (IN1) = use of (chemical) products outside the machine.
Turn to the right (max. till 10) to increase, back to left to decrease the product (scale: 0-10).
* For the product on the left side (IN1)= use of (chemical) products from the tank in the machine.
Turn to the left (max. till pos. 10) to increase, back to the right to decrease the product (scale: 0-10).
The mixer tap is carried out with two calibrations, there’s thus a choice to use two products.
Pay attention: you can suck only one product, not both.
The mixing tap works only well if the suction hose has been hung suciently under the fluid level in the tank. The
cleaner is provided with an injector to add products to the water. When the spray activities are finished:
- The injector need to suck pure water for a while to rinse the system suciently.
- Put the mixing tap on position 0 to prevent a back flow of product to the water tank.
7. Softener tank
Fill the softener tank with softener liquid by loosening the softener cap at the back of the serving panel.
The softening pump takes care for the dosage of the softener liquid to the water supply conduit.
The tank has a capacity of 1 litre. Pay attention: during the filling, the maximum filling value of the tank may not be
exceeded (see technical data, chapter 11).
The softener pump is also equipped with a level protection (run dry protection). If the softener pump will be filled
(above run dry level), the softener pump will dose the product inside the float tank (water supply) as long as the
fuel valve is active (burner on). If the fuel valve is inactive (burner stops), the softener pump also stops working.
When the level in the softener tank decreases below the run dry level, the softener pump will stop dosing.
8. Fuel tank
The fuel tank can be filled with by loosen the fuel cap at the back side of the serving panel.
The tank is provided of an air releasing, suction conduit and an return conduit on the top.
The tank has a capacity of 50 litres. Pay attention: during the filling, the maximum filling value of the tank may not
be exceeded (see technical data, chapter 11).
9. Chemicals tank
The chemicals tank can be filled by loosen the chemical cap at the back side of the serving panel.
With the internal tank one can suck in a product. There exist even a possibility through connecting the external
hose and -tank to add a second product. You can’t suck in both products! The tank has a capacity of 45 litres.
Pay attention: during the filling, the maximum filling value of the tank may not be exceeded (see technical data,
chapter 11).
Important:
At every filling cap, an air release hole has to be provided with a diameter of 6 mm.
So check every filling cap on an air release hole.
10. Water tank
The water tank has a volume of 12 litres and is equipped with a float system to shut of the water supply through
the float valve when the tank is filled. The anti- product siphoning system is standard provided in the water tank.
The system prevents that possible chemical water directly flow back to the water tank (due to water siphoning).
Remark: only at full- option version there’s a level protection present on all tanks!
11. Safety valve
When the water pressure rises above the adjusted safety pressure, the safety valve opens and there flows water
pressureless out of the cleaner at the bottom.
To Next Page
Loading...
Need help?
General
