Dickson KT6P Manual V3
DICK
DICKDICK
DICKSON
SON SON
SON
KT6P1 / KT6P2 / KT6P5
KT6P1 / KT6P2 / KT6P5KT6P1 / KT6P2 / KT6P5
KT6P1 / KT6P2 / KT6P5
Remote Sensing
Remote SensingRemote Sensing
Remote Sensing
Temperature
TemperatureTemperature
Temperature
Recorder
RecorderRecorder
Recorder
GETTING STARTED
GETTING STARTEDGETTING STARTED
GETTING STARTED
7-day chart rotation
0 to 100
o
F
QUICK START
QUICK STARTQUICK START
QUICK START
1.
1.1.
1. Remove the protective pen cap.
2.
2.2.
2. Connect Probe: Make sure the KTC probe is connected firmly to the Replaceable Sensor
and that the Replaceable Sensor is plugged in firmly to the chart recorder.
3.
3.3.
3. Insert 4AA batteries and plug in AC adapter (See Figure 3). Unit will power on.
4.
4.4.
4. The instrument will move pen to the appropriate readings.
5.
5.5.
5. Install the chart that matches the Dip Switch settings (See p.4).
Press the PEN
PENPEN
PEN
HOME
HOMEHOME
HOME key to move the pen to the outside of the chart. The pen is
automatically raised off the chart.
Remove the old chart, place the new chart on the Chart Hub being certain that the edge
of the chart slides under the Chart Guide Clip located at the outside of the chart.
6.
6.6.
6. Set the appropriate time. There are two ways to adjust the chart and set the appropriate
time:
a. Set the chart time manually by inserting a coin into the groove in the chart hub
and turning clockwise until the correct hour (and day if applicable) on the chart
is referenced to the timing arrow (just to the right of the pen tip on the dial).
Press Pen
PenPen
Pen
Home
HomeHome
Home to move the pen(s) back onto the chart.
The following feature should be used for fine adjustments only.
b. To adjust the chart time, press and hold Adjust
AdjustAdjust
Adjust-
--
-Up
UpUp
Up and Adjust
AdjustAdjust
Adjust-
--
-Down
DownDown
Down buttons
located on the back of the unit next to the dip switch (see Figure 3).
The green LED will blink rapidly for about five seconds, then the LED will remain
solid green. While in this state the Adjust
AdjustAdjust
Adjust-
--
-Up
UpUp
Up button will move the chart
backward (counter clockwise) and the Adjust
AdjustAdjust
Adjust-
--
-Down
DownDown
Down button will move the chart
forward (clockwise).