Dickson KT6P1 - Page 3

Dickson KT6P Manual V3
3
Keypad and Button Functions
Keypad and Button FunctionsKeypad and Button Functions
Keypad and Button Functions
On/Off
On/OffOn/Off
On/Off
The On/Off key turns the unit on and off.
Pen
PenPen
Pen Home
HomeHome
Home
If the pen is located on the outside edge of the chart, press Pen
PenPen
Pen Home
HomeHome
Home to move pen to recording
position. If the pen is located on the chart, press Pen
PenPen
Pen Home
HomeHome
Home to move the pen to the outside
edge of the chart.
A
AA
Alarm
larm larm
larm (
((
(KT6P5)
KT6P5)KT6P5)
KT6P5)
1.
1.1.
1. To set the alarm, make sure unit is on and press and hold the Alarm
AlarmAlarm
Alarm button. The LED will
blink red rapidly for about five seconds, then the LED will turn solid green. Release the
Alarm
AlarmAlarm
Alarm button and the LED will turn solid red. At this point the display will show “On” or “Off”.
Pressing either the Adjust
AdjustAdjust
Adjust-
--
-Up
UpUp
Up or Adjust
AdjustAdjust
Adjust-
--
-Down
DownDown
Down buttons, located on the back of the unit next
to the dip switch, will toggle the alarm on or off.
2.
2.2.
2. Pressing PEN
PENPEN
PEN HOME
HOMEHOME
HOME will scroll to the next alarm option. The options are as follows:
Alarm on or off
Pen 1 alarm minimum
Pen 1 alarm maximum
3.
3.3.
3. In order to set pen alarm minimum and maximum, pressing Adjust
AdjustAdjust
Adjust-
--
-Up
UpUp
Up will increase the
alarm value, and pressing Adjust
AdjustAdjust
Adjust-
--
-Dow
DowDow
Down
nn
n will decrease the alarm value. There is acceleration
if the Adjust
AdjustAdjust
Adjust-
--
-Up
UpUp
Up button is held down.
Repetitively pressing the Pen
PenPen
Pen Home
HomeHome
Home button will scroll through the three options until the
A
AA
Alarm
larmlarm
larm button is pressed to exit from alarm adjust. Each press of the Pe
PePe
Pen
nn
n Home
HomeHome
Home or Alarm
AlarmAlarm
Alarm
button will store the new settings. The unit will take one minute to exit Alarm Set Mode
once the Alarm
AlarmAlarm
Alarm button is pressed.
4.
4.4.
4. If the alarm is triggered, the LED will show as solid red and the alarm will sound. Press the
Alarm
AlarmAlarm
Alarm button to silence the audible alarm.
Alarm Relays
Alarm RelaysAlarm Relays
Alarm Relays (KT6P5)
(KT6P5)(KT6P5)
(KT6P5)
The SPST 24V 500mA relay contacts are normally open and will close on alarm conditions when
the alarms are enabled. Relay contacts are always functional when the alarm is enabled. The
relay will close only during minimum and maximum alarm conditions. Relays will not operate
under battery only power conditions