• 11 •
Smart Cable LED and Alarm Behavior
BEHAVIOR REASON
Green LED ashing Ready to connect the smart cable to
the jump starter, and ready to connect
the clamps to the vehicle.
Green LED solid
(with clicking sound)
Detecting the condition of the vehicle
and jump starter.
Green LED solid Ready to jump start the vehicle. After
jump start, disconnect the clamps.
Red LED lit (no alarm) Voltage is too high or too low for
starting a vehicle.
Red LED lit; long buzzer alarm The connection is reversed.
Short circuit protection.
Overload protection.
NOTE: Disconnect and reconnect the smart cable to reset.
12. SPECIFICATIONS
Battery type ................................................ Lithium Polymer, 37 Wh
Peak current ............................................................................. 800A
Starting current .........................................................................400A
Light ...................................................................Cree
®
LED, 600 lm
Micro USB input .....................................................................5V, 1A
USB output .......................................................................... 5V, 2.1A
Cree
®
is a registered trademark of Cree, Inc.
13. REPLACEMENT PARTS
USB to Micro USB charging cable .................................3899003982Z
Smart cable/clamps ........................................................3899003986Z
Bag for accessories ........................................................5899000037Z
14. BEFORE RETURNING FOR REPAIRS
When an UNKNOWN OPERATING PROBLEM arises, please read
the complete manual and call the customer service number for
information. This will usually eliminate the need for return.
If the above solutions do not eliminate the problem, or for
information about troubleshooting, call toll-free from anywhere
in the U.S.A.: 1-800-621-5485.
To Next Page
Loading...