Particle Analysis
1. Recommended Procedure
1)
Use a coffee ground spoon to scoop an appropriate amount of ground coffee into the center
area of the particle analysis tray.
2) Click to power up, put the main unit over the particle analysis tray. Make sure the meganetic
ports are connected.
3) Swipe from left to right on READY page to enter the menu page. Click on the 'Particle' button
to start test. The screen will display result After the completion of the test. (See page 13
for more details)
2. Analysis Result
(See Page 14 For More Details)
3. Test
1）
If the amount of coffee ground taken is more than one at spoon, the analysis of ner
particles may be affected.
2）
After the Smart Diffusor function is turned on, it can automatically conduct diffusion according
to the current particle distribution. If the particles have already been evenly distributed, the
diffusion will not be carried out again.
3）
During testing, the particle analysis tray will beep when diffusing the particle, which is a
normal phenomenon.
4. Sampling Recommendations
1）For coarse grind, please take two-thirds of a spoonful of ne powder.
2）For ne grind, please control it to one-third of a spoonful of ne powder.
3）If the grind cannot be determined, please take half a spoonful of ne powder.
4）You can adjust the sampling amount according to the actual situation to achieve better
dispersion and uniformity.
9
To Next Page
Loading...