To Next Page

To Previous Page

Control Buttons

Select programming mode

Turn ON/OFF program

Start/stop a manual cycle

Move left/right to select a value

Raise/lower the selected value

5. INSTALLING THE BATTERIES

1. Open the battery compartment cap by

turning it counter-clockwise.

2. Install two, fresh, brand name, AA

alkaline batteries (not included)

and note the proper direction of the

positive and negative orientation on the

underside of the timer.

3. Insert and screw the battery cap

clockwise. Make sure to securely

tighten the cover ﬁrmly by hand only.

The timer display appears with a day,

PM, and the hour digit ﬂashing. The timer

is ready to be installed and programmed.

Questions and Answers:

Need help?

Do you have a question about the DIG RBC 8000 and is the answer not in the manual?

DIG RBC 8000 Specifications

General