Digi Connect Series - Page 6

Digi Connect Family Application Guide – Digi to Juniper Configuration
3/16/2009 Digi International 6 of 9
6. Click New in the upper right hand corner and fill in the following information (shown
in the following screenshot):
a. Security Level – Custom
b. Remote Gateway Type – Can be static or dynamic. This example will use
static.
c. IP Address/Hostname – The mobile IP or hostname of the Digi gateway.
d. Peer ID – The ID that the Digi gateway is using.
e. Preshared Key
f. Local ID – The ID that the Juniper unit is using.
7. Click Advanced and fill in the following information (shown in the following
screenshot):
a. Phase 1 Proposal – pre-g2-3des-sha
b. Mode (Initiator) - Main