Digi SM-5100 - Page 20

SM – 5100 Operation Manual
20
 Five Modes can be selected using this key.
 Indicator R - REGISTRATION MODE (All the sales
transactions are performed.)
 Indicator X - CHECK MODE (Printing out and sales report.)
 Indicator S - PROGRAM MODE (Programming preset data,
such as products, data, shop name, etc.)
 Indicator Z - TOTAL MODE (Clear sales data stored.)
 Indicator X (Blink) - Password Setting Mode (Set PASS WORD
for X, S, Z mode, set PASSWORD for PASSWORD MODE
when all indicators(R, X, S, Z) blink)
Decrease/Increase Specification Count key
︽,︾
 Decrease/Increase Only used when Setting SPEC 141 & 142
<<,>
>
 Select parameter data such as SPEC data. Move cursor left or right.
2.7 Indicators
 ZERO : On when zero point is adjusted and weight is stable.
 NET : On when tare subtraction is performed.
 FIX T : On when tare weight is fixed.
 FIX P : On when PLU or unit price is fixed.
 P : On when pre-pack mode is chosen; indicate capital letter is use in PLU
programming.
 M : On when manual mode is chosen.
 V1 ~ V4: On when vendor transaction entries (department entry or PLU entry) are
performed.
 LABEL: On when label printing mode is chosen.
 R : On when in R (normal operation) mode.
 X : On when in X (read report) mode.