SM – 5100 Operation Manual
38
4.6 PLU Programming
The following items can be programmed in PLU PROGRAMMING mode. The format chosen
for the PLU will decide what items can be programmed in the PLU file. The items which print
areas are not set on the selected format will skip automatically or not printed on label. (If the item
doesn't appear on the PLU programming, check whether the parameter is set to ENABLE in
Program / Skip Item Data).
PLU file for weighing item and non-weighing item listed below can be programmed according to
the following order.
Weighing Item
Label Format for the 1st label
Refer to Label Format List.
Label Format for the 2nd label
Free format No.1~99 only.
Selection of ITF Barcode Format
* Digits of Flag and Item data can be selected in the
barcode type selection in S1.6.
Item Code No. (Lower 4 digits)
Only when Item Code is more than 6 digits.
Right Side Data of Item Barcode
Only when Spec02 set to 3.
Select whether to print Sell by date
* If No Print is selected, Sell- by Date in S1.12 is skipped.
Sell by date (Days after the current date)
Select whether to print Sell by time
* If No Print is selected, Key in selection in S1.14 Sell-by
time in S1.15 is skipped.
Select key-in data or present time
* If S1.14 select CLOCK TIME, Key in selection in
S1.15 is skipped.
Sell by Time (If Key-In is selected)
Select whether to print Used by date
* If No Print is selected, Used- by Date in S1.17 is
skipped.
Used by date (days after Packed date)
Select whether to print Packed date
* If No Print is selected, Packed Date in S1.19 is
skipped.
Packed Date (days after actual packed date)
To Next Page
Loading...
