Digi SM-5100 - Page 60

SM – 5100 Operation Manual
60
4.10 Advertisement File
Advertisement message is the sales promotional description on the label, such as “FOR
BARBECUE” or “FRESH”. Advertisement message is printed in the print area of the
Commodity Name. If Commodity Name occupies all of the print area, there will be no room
for the Advertisement Message and it will therefore not be printed. Maximum 2 lines can be
programmed for each Advertisement Message and up to 64 (Advertisement # 1~64)
advertisement messages are available.
To print advertisement message on a label, [ADVERTISEMENT] Function Key must be
assigned to a preset key in advance.
Note: Advertisement message print on all label can be set at SPEC 96, printing position can be
set at SPEC 14 and printing method can be set at SPEC 15.
4.10.1 Program Advertisement File
At Programming Mode, select Advertisement programming mode and then enter new
Advertisement number (Ex. 1) programming mode.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
[MODE][MODE]
[MODE]
S1
→
PLU
FILE
Enter S mode.
Lamp S turns on.
[6] or [ ︾ ] five
times
S6
→
ADVE
R
MESSAGE
Select advertisement file programming
mode.
[*]
S6.0
ADVE
R
0
NO SET
Enter advertisement File programming
mode.
[1][*]
S6.1
A01.01
S1 A 100
Enter the advertisement File
No.1(Ex.No.1)
[T][H][A][N][K][S
P][Y][O][U]
S6.1
A01.10
K YOU
S1 A 91
Enter the advertisement as the same
procedures as Commodity Name Entry.
(Ex. “THANK YOU”)
[SIZE]
S6.1
A01.10
K YOU
S2 A 76
Press [SIZE] key to change font size of
the advertisement file.
[SIZE]…[SIZE]
S6.1
A01.10
K YOU
L5 A 21
Change font size to L5.
(S1~S5; M1~M5; L1~L5)