Digi SM-5100 - Page 63

SM – 5100 Operation Manual
63
4.11 Vender File
Vender file is used for programming names of operators. Maximum 16 characters can be entered
per Vender name. A programmed Vender number can be assigned to a preset key. The Vender
Number or Name (Depend on Spec 21 setting) will be printed on the label, if selected label
format with print area for Vender Number and the programmed Vender name can be printed on
receipt when SPEC 21 set to NAME.
4.11.1 Program Vender File
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
[MODE][MODE]
[MODE]
S1
→
PLU
FILE
Enter S mode.
Lamp S turns on.
[7] or [︾] six times
S7
→
VENDER
FILE
Select Vender file
programming mode.
[*]
S7.0
CLERK
0
NO SET
Enter Vender File
programming mode.
[1][*]
S7.1
CLERK
1
NAME 0
Select vender key.(Ex. V1)
Program operator name for
Vender 1.
[M][I][K][E]
S7.1
CLERK
MIKE
NAME 4
Enter operator name for
V1.(Ex. “MIKE”)
[PLU]
S7
→
VENDER
FILE
Store Vender File V1,back to
S mode.
Note1: V1 – V99 can be programmed