Digi SM-5100 - Page 65

SM – 5100 Operation Manual
65
4.13 Special Message File
Special Message can be used as a description on the label such as receipt, which can be assigned in
each PLU. Since standard format does not have a print area set for Special Message, Special
Message cannot be printed when using these formats. To print Special Message on the label, it is
required to use a Free Format with a Special Message print area programmed. Maximum 16
special messages can be programmed with each up to 8 programmable lines. Number of line is
depends on the size of the print area or Character Size entry. The default Special Number print on
Receipt can be set at SPEC 112 and printing position can be set at SPEC 125.
Note: If SPEC 43 set to RECEIPT, maximum 8 lines can be programmable for each Special
Message Number and without select a required Free Format.
4.13.1 Program Special Message File
At Programming Mode, select Special Message programming mode and then enter new Special
Message number (Ex. 1) programming mode. *For edit, enter existing Special Message number.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
[MODE][MODE]
[MODE]
S1
→
PLU
FILE
Enter S mode.
Lamp S turns on.
[9] or [ ︾ ] eight
times
S9
→
SP
MESSAGE
Select special message file programming
mode.
[*]
S9.0
SP MG
0
NO SET
Enter special message File programming
mode.
[1][*]
S9.1
M01.01
S1 A 100
Enter the special message File
No.1.(Ex.No.1)
[M][A][D][E][SP][I][
N][SP][C][H][I][N][
A]
S9.1
M01.14
CHINA
S1 A 87
Enter the special message File as the
same procedures as Commodity Name
Entry.
(Ex. “MADE IN CHINA”)
[SIZE]
S9.1
M01.14
CHINA
S2 A 72
Press [SIZE] key to change font size of
the special message File.
[SIZE]…[SIZE]
S9.1
M02.01
CHINA
M3 A 62
Change font size to M3.
(S1~S5; M1~M5; L1~L5)