SM – 5100 Operation Manual
91
4.19 Logo File
Logo is the trademark of the shop, which will be printed in Label or Receipt. Logo will be
printed on the top of receipt and on the left side of shop name on label. (When printing Logo
data on Free Format Label, set the print area of Logo data on the Free Format in advance.)
Logo data can be programmed up to 4 logos. When using 4 logos for label, assign the LOGO
KEY to preset key in advance. A logo data is formed by a pattern of dots (128 horizontal dots
and 64 vertical dots.) However, since the Label logo data is printed within the limits, which are
programmed in label formats, program the logo data within the limits of print area on the
format.
Note: All standard formats have 37 dots x 30 dots for logo print area.
4.19.1 Pre-programming Logo Data
1) Prepare a section paper with 128 horizontal dots and 64 vertical dots.
2) When programming Label Logo, draw the limit of the Logo print area.
3) Draw the desired logo design in the section paper by filling the section with dot. (The dots
are necessary to seize the image of the actual logo before programming.)
Example: DIGI Logo for label (37 x 30 dots)
To Next Page
Loading...
